Total Heating & Cooling Care Plan

Total Cooling & Heating Maintenance Care Plan Agreement – Gold Level ($29.95/month)*

With the Total Cooling & Heating Plan you receive full coverage for both your cooling and heating systems.  In addition to the benefits of our Seasonal Care Plan (15% discount on all repairs, 2 maintenance visits per year (heating and cooling), Priority Service 24-7, optional electrical and plumbing safety evaluation per year and just a $60 diagnostic service call any time or day), you also receive :

  • 100% coverage parts and labor for all cooling and heating repairs up to a $1,000 limit per occurrence.
  • You can apply the cost of the repair (up to $1,000 limit)  towards a new piece of equipment if you decide it is smarter to replace the equipment rather than repair it.

Cost of plan is $29.95 a month*

Repairs including 

  • Heat Exchanger
  • Evaporator Coil
  • Condensing Coil
  • Compressor
  • Thermostat
  • Refrigerant
  • Thermocouple
  • Belts, Valves, Controls
  • Blower Motors
  • Fans
  • Circuit Boards
  • Blower Wheel
  • Fan Motors
  • Gas Regulator and Pilot
  • Ignition Controls and Sensors
  • Transformers, Capacitors, Relays
  • Cycle Timer
  • Boiler Controls
  • Safety and Overload Controls

*base level coverage
** 100% coverage parts and labor applies only to hvac repairs on issues not existing prior to the beginning date of coverage

Click here for Apollo Home Care Plan Terms & Conditions

15-Point Master Heating Tune-Up

  1. Test and adjust safety and operating controls
  2. Test gas valve or oil pump operation
  3. Inspect for combustion leaks
  4. Test and tighten all wiring and connections
  5. Conduct carbon monoxide testing
  6. Adjust and clean thermostat
  7. Inspect heat exchanger and clean burner(s)
  8. Adjust burner(s) for maximum efficiency
  9. Inspect flue pipe and draft diverter or barometric damper
  10. Adjust and clean electrode or pilot assembly
  11. Check blower motor (and belt if applicable)
  12. Drain expansion tank or install customer supplied air filter
  13. Replace oil filter and nozzle or test and adjust pressure regulator
  14. Lubricate all motors, bearings, fans and circulators
  15. Inform customer of equipment condition and provide printed report.

 

15-Point Master Cooling Tune-Up

  1. Lubricate all moving parts
  2. Safety test all controls for proper operation
  3. Install gauges; record operating pressures and temperatures
  4. Inspect start and run capacitors and relays for bulges, rust and leaks
  5. Measure refrigerant superheat to fine-tune its charge
  6. Flush condensate drain to protect against overflow
  7. Tighten and safety test all wiring and connections
  8. Check blower motor (and belt if applicable)
  9. Test “temperature drop” at return and supply air; adjust blower
  10. Adjust and clean thermostat
  11. Meter voltage and amperage in all motors; test for worn bearings
  12. Test condition of compressor contacts
  13. Check air filter; clean or replace with customer supplied filter
  14. Clean outdoor condenser coil
  15. Inform customer of equipment condition and provide printed report


How to Videos

    Shutting off water to your home